# 🧰 Manual for Testers: Pairing a Z-Wave Device

### 1. Open Device Page

You should be redirected to the **Z-Wave adapter page**. Click **Add Device**.  
If not redirected, go to:

> **Settings → Devices & Services → Z-Wave → SLZB-MRW10**

[![image.png](https://smlight.tech/support/manuals/uploads/images/gallery/2026-07/scaled-1680-/H1Timage.png)](https://smlight.tech/support/manuals/uploads/images/gallery/2026-07/H1Timage.png)

### 2. Choose Pairing Method

Choose your preferred pairing method:

<table id="bkmrk-method-ease-notes-sc"><thead><tr><th>Method</th><th>Ease</th><th>Notes</th></tr></thead><tbody><tr><td>**Scan QR‑code using web-cam**</td><td>⭐⭐⭐</td><td>Easiest &amp; secure if the device has a SmartStart label.</td></tr><tr><td>**Enter QR-code manually**</td><td>⭐⭐</td><td>Secure S2 inclusion when QR‑code isn’t available.</td></tr><tr><td>**Search for device**</td><td>⭐</td><td>Put device in pairing mode, then let the hub discover it.</td></tr></tbody></table>

We will use the third method.

[![image.png](https://smlight.tech/support/manuals/uploads/images/gallery/2026-07/scaled-1680-/EzJimage.png)](https://smlight.tech/support/manuals/uploads/images/gallery/2026-07/EzJimage.png)

### 3. Put Device into Pairing Mode

Follow your device’s instructions to enter pairing mode.

[![image.png](https://smlight.tech/support/manuals/uploads/images/gallery/2026-07/scaled-1680-/u2Eimage.png)](https://smlight.tech/support/manuals/uploads/images/gallery/2026-07/u2Eimage.png)

### 4. Wait for Device Info

Z-Wave will begin requesting information from the device.

[![image.png](https://smlight.tech/support/manuals/uploads/images/gallery/2026-07/scaled-1680-/sziimage.png)](https://smlight.tech/support/manuals/uploads/images/gallery/2026-07/sziimage.png)

### 5. Enter Requested Data

If prompted, enter required details (e.g., **PIN code** found on your device).

[![image.png](https://smlight.tech/support/manuals/uploads/images/gallery/2026-07/scaled-1680-/5apimage.png)](https://smlight.tech/support/manuals/uploads/images/gallery/2026-07/5apimage.png)

### 6. Device Added!

The device is now ready for use. You’ll be redirected to the device page where you can monitor and control it.

[![image.png](https://smlight.tech/support/manuals/uploads/images/gallery/2026-07/scaled-1680-/lt8image.png)](https://smlight.tech/support/manuals/uploads/images/gallery/2026-07/lt8image.png)

### ✅ You’re all set! Your Z‑Wave device is now fully integrated and ready for automation with the SLZB‑MRW10 adapter.

---

📋 **Post‑Pairing Tips**

- Rename entities to something meaningful (e.g., Kitchen Motion Sensor).
- Assign the device to an Area to keep your dashboard tidy.
- If a secure device fails to interview fully, exclude it first, then re‑include closer to the hub.