Device update

Update using the web tool

SLZB-07/MGx:

• Go to https://smlight.tech/flasher/
• Press Update SLZB-07 Firmware button
• Select SLZB-07x/MGx dongle serial port
• Wait for connection
• Select firmware (Coordinator/Router/Thread)
• Flash firmware

If you get an error:

• Unplug your coordinator
• Open enclosure
• Connect pad FLSH with the GND or any metal part of the antenna (you can use tweezers or scissors)
• Plug the coordinator to your PC (keep FLSH connected to the GND)
• Run flashing

TIP: You can insert a screwdriver near the antenna to make it easier to disassemble the case.

SLZB-07pX:

• Go to https://smlight.tech/flasher/
• Press Update SLZB-07pX Firmware button
• Select SLZB-07pX dongle serial port
• Wait for connection
• Select firmware (Coordinator/Router/Thread)
• Flash firmware

If you get error:

• Refrash page
• Click on Update SLZB-07pX Firmware button again

Update using third-party tools

Flashing via Home Assistant addons

SLZB-07/MGx; https://github.com/home-assistant/addons/tree/master/silabs_flasher
Example config:

SLZB-07Px: https://github.com/tube0013/tubeszb_addons/tree/main/tzb-cc2652-flasher/
Example configuration:

Community firmware

SLZB-07/MGx

• https://github.com/darkxst/silabs-firmware-builder/tree/main/firmware_builds
• https://github.com/Nerivec/silabs-firmware-builder/releases

SLZB-07P7

• https://github.com/Koenkk/Z-Stack-firmware/releases

  Please use CC1352P7_coordinator_* firmware for SLZB-07P7!
  Incorrect firmware can brick your device!
  

SLZB-07P10

Sorry, there is no community firmware at this time.