Skip to main content

SLZB-xxU and ZWA-2

???? Using ZWA-2 Z-Wave Dongle with SLZB-MR1U via USB Passthrough

Overview

Many users asked whether the ZWA-2 Z-Wave USB stick can be used with the SLZB-MR1U using its USB passthrough over Ethernet feature.

Until recently, we were unable tocouldn’t confirm this — as it had nothadn’t been tested in-house.

We have now testedcompleted this setup,testing and we can confirm:

ZWA-2 works reliably with SLZB-MR1U using USB passthrough.


???? What You NeedRequirements

  • SLZB-MR1U hardware

  • SLZB-OS firmware v3.0.0 or newer

  • ZWA-2 USB Z-Wave stick

  • Z-Wave JS UI (or other TCP-compatible integration)Z-Wave host)

  • AccessNetwork access to the SLZB-MR1U'sMR1U IP address on your local network


???? Why SLZB-OS v3.0.0?

Firmware v3.0.0 (released 29 August 2025)2025) includes:is required because it:

  • Fix forResolves USB passthrough stabilityinstability


  • Fix forFixes EFR32 firmware update failures (Thread radio)


  • ???? GeneralImproves improvements foroverall SLZB-MR1U reliability

  • You

can

Itupdate is the recommended version for using external USB devices with MR1U.

???? Update options:via:


???? Setup Instructions

  1. Flash your SLZB-MR1U with SLZB-OS v3.0.0

  2. Plug the ZWA-2 USB stick dongle into the USB-A port

  3. Open Z-Wave JS UI on your smart home host system

  4. ConfigureSet the serial port:port to:


    tcp://<SLZB-MR1U-IP>:8638
  5. Save settings and restart Z-Wavethe JS UIservice

  6. Pair your Z-Wave devices as usual


⚠️ Notes and& Best Practices

  • Only one USB device is supported at athe time (multi-USB support is in development)moment

  • MakeMulti-device sureUSB support is under development

  • Ensure port 8638 is accessible on your networkLAN

  • Avoid running USBusing passthrough whileand EFR32 firmware flashing EFR32simultaneously (Thread)just — even though the issue is resolved, it'sas a goodbest practice to keep those tasks separatepractice)


Troubleshooting

IssueProblem Solution
ZWA-2 not detected CheckConfirm IP addressand andport, check firmware version (must beis v3.0.0+)0 or newer
Devices won’t pair Restart Z-Wave JS UI andafter verifyconfiguring the serial configport
Unstable USB device disconnectsconnection Use a bettershorter or higher-quality USB cable (or powered hubUSB (if needed)hub)