Search Results

Executive summary: SLZB-06 series - can run Zigbee and Thread (and capable for Multiprotocol, but not recommended by Home Assistant and deprecated), connects over Ethernet, could be powered by PoE or Type-C (if you do not have PoE - can connect Ethernet and...

Prerequisites: SLZB-07x Zigbee USB coordinator. Computer or Raspberry Pi where Zigbee2MQTT or Home Assistant with ZHA will run. Home Assistant + ZHA or Zigbee2MQTT software installed. Steps: Install Zigbee2MQTTFollow the installation instructions fo...

Update using the web tool SLZB-07/MGx: Go to https://smlight.tech/flasher/ Press Update SLZB-07 Firmware button Select SLZB-07x/MGx dongle serial port Wait for connection Select firmware (Coordinator/Router/Thread) Flash firmware If you get an erro...

Use a thin and sharp tool for opening the device cover. Insert it into the center of the terminal connector as shown in the photo below: Once the tool is inserted, start pulling the PCB down from the Type-C connector side:

General information: USB stick in Zigbee router mode expands your existing Zigbee network: amplifies the signal increases the maximum number of devices in the network by 32 Important: you need to pair the stick to your Zigbee network for it to start ...

Zigbee Hub mode has the ability to connect to local or remote MQTT brokers. Currently only TCP connections are supported.This document describes MQTT API for SLZB-OS 3.0.9 or higher Topics are divided into IN and OUT.IN - you can send messages to these topi...

How to open device Prepare a flat, thin tool. This can be a small screwdriver. Insert the tool from above, between the Type-C port and the case. Carefully pull the top cover forward using the tool, leaning against the Type-C Carefully pull off the top an...

General information The SLZB-OS operating system has several API channels: HTTP, SSE and MQTT. When using any of these channels, it is not recommended to send more than one request per second.A large number of requests per second can slow down the coordinato...

Addon setup Flash the Thread firmware. Please follow this manual for device update instructions https://smlight.tech/support/manuals/books/slzb-07pxmgx/page/device-update Install the OTBR addon into your Home Assistant OS (HAOS) If your HA is installed in...

General information This feature is supported only by "U" series devices and SLZB-Ultima(CPU model: ESP32S3) USB to Ethernet passthrough mode allows connecting a USB device to your coordinator USB port (directly or via a USB hub) and using such USB devices r...

Prerequisites A server with Home Assistant installed and running. In this manual, we are using Raspberry Pi 4 with clean fresh install of HAOS. An SLZB-06 or MR families Coordinator flashed with OpenThread Border Router firmware. In this manual, we use SML...

WHAT IS VPN WIREGUARD This is a feature of SLZB-OS that allow them to connect to remote Home Assistant / Zigbee2MQTT server through secure VPN tunnel without any additional hardware. WireGuard is an extremely simple yet fast and modern VPN that utilizes sta...