Recently Updated Pages
Device update
Precompiled firmware 1. Install driver: https://learn.sparkfun.com/tutorials/how-to-install-ch34...
SLZB Series Overview
Executive summary: SLZB-06 series - can run Zigbee or Thread (and capable for Multiprotocol, b...
v3.3.5.dev1
Where did the changes take place? Zigbee Hub mode users (Does not apply to you if you are using ...
SMHUB-OS release notes
OS v1.0.0 TL released on 20260710 The official, stable release of SMHUB OS v1.0.0 is finally here...
SMHUB OS - Update & Restore Methods
Your SMHUB can be updated or restored in three different ways: OTA (recommended) – simple up...
Update/Restore using SD-Card
💾 SD-Card Installation Guide NoticeThe direct SD-card installation method is temporarily unavaila...
Update/Restore using Type-C
Flashing over Type-C SMHUB Flasher Starting with SMHUB OS v1.0.0.dev4, you can use the SMHUB Fl...
Thread setup (network and USB connection)
Thread setup for Home Assistant: two options SLZB devices support two ways to run a Thread netwo...
Zigbee network sniffing guide for SLZB-MRx and SLZB-06Mx adapters
Prerequisites 1. Coordinator You will need coordinator with EFR32 radio module from Silicon Lab...
Frequently Asked Questions (FAQ)
The Ethernet connection is not working, what should I check? A: Ensure the Ethernet module ...
Troubleshooting
This section lists common issues you may encounter while using the SLWF-09, along with their poss...
Wiring and Installation
This section explains how to connect the SLWF-09 controller, add-on modules, and LED strips safel...
Hardware Overview
The SMLIGHT SLWF-09 is designed as a modular, ESP32-based LED controller with optional add-on boa...
Introduction
Thank you for choosing the SMLIGHT SLWF-09, our most flexible, modular, and feature-rich LED cont...
Technical Specifications
The following table lists the key hardware and electrical specifications of the SMLIGHT SLWF-09 L...
SLZB-OS API endpoints
General information The SLZB-OS operating system has several API channels: HTTP, SSE and MQTT. ...
SMHUB Early Adopter – Quick Start Guide
The SMHUB Early Adopter Version is the first public release of our multi-radio smart hub. It’s de...
SMHUB Peripheral (IR, Buzzer, Ambilight) Control Guide
🎛️ SMHUB Peripheral Control Guide IR • Buzzer • WS2812 (Ambilight) This page documents how to c...
Wire Guard VPN setup
WHAT IS VPN WIREGUARD This is a feature of SLZB-OS that allow them to connect to remote Home A...
Thread setup
Addon setup Flash the Thread firmware. Please follow this manual for device update instruction...